The jewel light will illuminate when the mains switch is set to ON. The Output switch should be set to STANDBY prior to performance. Refer to ‘Before Using Your Amplifier’.
Selects between 15 Watts (full power), Standby and 7 Watts (half power) modes.
7 Watts produces a different response and greater levels of output valve distortion/breakup at lower volume levels.
Use a quality shielded instrument cable to connect your instrument to the Input jack socket.
Adjusts the output volume level. At higher settings, the output stage will begin to breakup into natural overdrive. Experiment further with the Output switch to achieve the desired output level and response.
Note: with the Gain set to zero, no sound will be heard.
Adjusts the tonal response of the amp.
The Tone control acts as a ‘roll off’ for the upper frequencies. Turning fully anti-clockwise produces warmer tones. Turning fully clockwise produces brighter tones.
Adjust the Gain level for a wide range of tones, from mild overdrive through to heavy distortion. Lower Gain settings will produce cleaner tones and may require an increase in Volume to compensate.
Refer to ‘Before Using Your Amplifier‘ for full speaker cabinet options. If you are unsure, please contact your Orange dealer.
This fuse will blow in the event of output valve failure. Replace this fuse only with the exact type and rating as printed on the chassis.
Mains Input and Mains Fuse
Refer to ‘Before Using Your Amplifier‘. Connect the supplied IEC cable to the AC Mains Input. Ensure the Power switch is set to OFF before connecting the IEC cable. The mains fuse is located in the pull-out tray underneath the AC Mains Input. If the mains fuse blows, replace only with the exact rating for your region . If the mains fuse continues to blow contact your Orange dealer.
Voltage Selector Switch (side panel)
Refer to ‘Before Using Your Amplifier‘.
Fuses & Valves
Mains fuse (230V): T500mA
Mains fuse (100/120V): T1A
HT fuse: F250mA
Preamp and phase inverter: 2 x ECC83/12AX7 valves
Poweramp: 2 x EL84