Front Panel Features
LED will illuminate when the mains switch is set to ON.
Set the Volume control to zero/minimum before switching on power to the amplifier.
Adjusts the overall output volume level.
Controls the amount of upper harmonics blended with the clean signal. The character of the blended signal is defined by how the Gain control is set. Higher Blend settings will add extra volume, so you may adjust the master Volume to compensate if necessary. With the Gain set to minimum, the Blend control will have the least effect on the overall sound.
Rear Panel Features
1. Balanced Output
Sends a balanced line level signal (post-EQ, post-Blend, pre-Master Volume) to a mixer and/or PA system. Engage/depress the ground Lift button if ground hum becomes a problem when connecting the amplifier to external equipment.
Note: A speaker must remain connected when the DI Output is in use.
4. Speaker Outputs
Make sure the correct speaker load and power handling is connected at all times!
Refer to ‘Before Using Your Amplifier’
Total minimum impedance = 4 Ohms