The jewel light will illuminate when the mains switch is set to ON. The Output switch should be set to STANDBY prior to performance. Refer to ‘Before Using Your Amplifier’.
Selects between Full power, Standby and Half power modes.
A full range of output power options can be selected using both the Output switch and 4/2 Output Tubes selector (rear panel). 30 Watts produces more volume and clean ‘headroom’. Reducing the output power produces a different feel/response and greater levels of output valve distortion/breakup at lower volume levels.
Use a quality shielded instrument cable to connect your instrument to the Input jack socket.
Switches between the Tiny Terror and Fat channels. This can be switched remotely via a latching footswitch (rear panel).
Adjusts the volume level for the each channel.
Note: With the channel’s Gain set to zero, no sound will be heard.
Adjusts the tonal response of each channel.
The Tone control acts as a ‘roll off’ for the upper frequencies. Turning fully anti-clockwise produces warmer tones. Turning fully clockwise produces brighter tones. The Fat channel is voiced a little warmer/darker than the more aggressive Tiny Terror channel.
Adjusts the Gain level for each channel for a wide range of tones, from mild overdrive through to heavy distortion. Lower Gain settings will produce cleaner tones and may require an increase in Volume to compensate.
Connect a latching footswitch (e.g. FS-1) to switch between channels remotely. The Channel selector must be set to the Fat channel in order for the footswitch to function.
Refer to ‘Before Using Your Amplifier‘ for full speaker cabinet options. If you are unsure, please contact your Orange dealer.
4/2 Output Tubes
Combine with the Output switch for:
30 Watts: Full with 4
15 Watts: Full with 2
15 Watts: Half with 2 (different response)
7 Watts: Half with 2
Whether using 2 or 4 tubes, the impedance always matches what is displayed on the speaker jack sockets.
This fuse will blow in the event of output valve failure. Replace this fuse only with the exact type and rating as printed on the chassis.
Mains Input and Mains Fuse
Refer to ‘Before Using Your Amplifier‘. Connect the supplied IEC cable to the AC Mains Input. Ensure the Power switch is set to OFF before connecting the IEC cable. The mains fuse is located in the pull-out tray underneath the AC Mains Input. If the mains fuse blows, replace only with the exact rating for your region . If the mains fuse continues to blow contact your Orange dealer.
Voltage Selector Switch (side panel)
Refer to ‘Before Using Your Amplifier‘.
Fuses & Valves
Mains fuse (230V): T1A
Mains fuse (100/120V): T2A
HT fuse: T500mA
Preamp and phase inverter: 4 x ECC83/12AX7 (two per channel)
Poweramp: 4 x EL84