Adjusts the output level for each channel. Higher settings on the Clean channel will produce natural overdrive and breakup. Note: with the Dirty channel Gain set to zero, no sound will be heard on the Dirty channel.
The power light will illuminate when the Power switch (rear) is set to ON.
Adjusts the reverb level for both channels. Higher settings add longer trails for a spatial effect.
Send & Return
Use the Send jack to connect to the input of external effects processors/pedals. Connect the output of external effects to the Return jack on the amplifier. Time based effects (e.g. delays and reverbs) are often best placed in the Effects Loop, whereas overdrive pedals, filters and wahs etc. are usually best placed between the guitar and the amp’s Input. Experiment with placement to achieve the desired sound.
1. AC Mains Inlet
Refer to ‘Before Using Your Amplifier‘. Connect the supplied IEC cable to the AC Mains Inlet. Ensure the Power switch is set to OFF before connecting the IEC cable.
3. Voltage Selector Switch
Refer to ‘Before Using Your Amplifier‘.
Factory set to the region in which the amplifier is intended to be sold.